does it run and move, does it have any leaks, what is the reach on the unit 06/23/2026 10:17:30 AM

It runs great, it has the 5.9 12valve Cummins. Everything is fully operational on it and it drives good, no issues with steering or brakes. It does have two new steering cylinders and new brake master with booster. The engine leaks some from rear main seal and transmission has a minor leak somewhere. All hydraulics work as they should, has fairly new outrigger cylinders, no play in any of the pins and boom extends smooth with no issues. Machine was serviced before turn table bearing failure. Tires are just a couple years old, no dry rot that can be seen. The reach is 90 ft and has a 25 ft jib to go with it. It does not have A/C or heat. 06/23/2026 13:29:12 PM

you mentioned in your response to question #1 "...before turn table bearing failure.." so is the turn table brg. currentley bad? 06/25/2026 21:41:12 PM

Yes, the turn table bearing is bad! Something in the bearing let go and allows the upper half of the body with boom rock around some, when driving, you can feel the whole upper half rock back and forth and side to side. It's ok for transport or to drive around, It however is not safe to lift any load until bearing is replaced. CAT/Crane service came out and did an inspection and even said something in the bearing had failed. This is the only issue with the crane keeping it from being used. 06/26/2026 12:27:10 PM